Changing the Remote Unlock Verification Mode

Two ways to change the remote unlock verification mode:
^ Scan tool method.
^ Without a scan tool describe next:

1. Close all vehicle doors.
2. Turn the ignition switch on.
3. Press and hold unlock on either door lock switch.
4. While holding unlock on the door lock switch, press and release unlock on the keyless entry transmitter.

NOTE: The BCM sounds the chime a number of times equal to the current remote unlock verification mode.

5. To advance the mode: Press and release unlock again on the keyless entry transmitter.
^ The BCM sounds the chime a number of times equivalent to the remote unlock verification mode. A transition past mode 4 repeats the sequence starting with mode 1.
^ To exit and save the current customization mode: Release the door lock switch when obtaining desired mode.

If unable to change modes refer to Body Control Module Diagnostic Information in Body Control System for diagnosis and repair. Testing and Inspection