Ignition Coil: Service and Repair

REMOVAL PROCEDURE
1. Turn OFF the ignition switch.
2. Note position of spark plug wires for installation and disconnect the spark plug wires from ignition coils.
3. Remove the 2 screws securing ignition coil to ignition control module.
4. Remove the ignition coil.

INSTALLATION PROCEDURE
1. Install the ignition coil.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the 2 screws.

Tighten
Tighten the screws to 4-5 N.m (40 lb in).

3. Install the spark plug wires.