Wiper Motor Cover Replacement

REMOVAL PROCEDURE
1. Pull the retainer out of the harness connector.
2. Remove the harness connector from the wiper motor cover.
3. Remove three screws and the wiper motor cover from the wiper motor.

INSTALLATION PROCEDURE

NOTE: Refer to Fastener Notice in Cautions and Notices.

IMPORTANT: The cam must be in the position shown and the wiper motor must be in the park position so the drive pin will be in the open area of the cam during installation.

1. Install the wiper motor cover onto the wiper motor with three screws.

Tighten
Tighten three screws to 3 N.m (26 lb in).

2. Install the harness connector to the wiper motor cover.
3. Install the retainer into the harness connector.