Window Tilt Adjustment (Outboard/Inboard)

1. Mark all of the adjustments.
2. Loosen the stabilizer bracket assembly fore/aft and glass tilt adjustments.
3. Loosen the secondary glass tilt adjustment.
4. Adjust in or out as necessary the primary glass tilt adjustment in order to move the top of the glass.
5. Tighten the primary glass tilt adjustment nut.
6. Operate the window module in order to verify that the adjustments do not restrain movement.
7. Place the window in the full down position in order to ensure that the front guide channel is free for movement.
8. Tighten the secondary glass tilt adjuster.
9. Sit inside the vehicle in order to observe the back channel guide.
10. Close the door.
11. Operating the window, observe that glass moving upward does not damage the rear seal.
12. If the glass may damage the seal, return to step 1.
^ Damage to the seal indicates the glass tilts too far inboard.
^ If the glass does not tilt inboard enough for a proper position at the full up position, move outboard the seal retainer.
^ If the glass does not tilt outboard enough for a proper position at the full up position, move inboard the seal retainer.
13. Ensuring that the glass guidance module does not move, tighten the stabilizer bracket assembly adjustments.
14. Tighten all of the adjustments.