Rear

REMOVAL PROCEDURE

^ Tools Required
- J6627-A Wheel Stud Remover

1. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Wheels, Tires and Alignment.
2. Remove and support the caliper. Refer to Brake Caliper Replacement - Rear in Disc Brake Systems.
3. Remove the brake caliper support. Refer to Brake Caliper Bracket Replacement - Rear in Disc Brake Systems.
4. Remove the brake rotor. Refer to Brake Rotor Replacement in Disc Brake Systems.





5. Remove the wheel stud with the J6627-A.

INSTALLATION PROCEDURE
1. Install the new stud from the back side of the hub.





2. Install flat washers (1) on the wheel stud (2).
3. With the flat side of a wheel nut against the washers, tighten the wheel nut until the wheel stud head seats against the wheel hub flange.

Important: Ensure that the wheel stud is fully seated against the wheel hub flange.

4. Install the brake rotor. Refer to Brake Rotor Replacement in Disc Brake Systems.
5. Install the caliper support. Refer to Brake Caliper Bracket Replacement - Rear in Disc Brake Systems.
6. Install the brake caliper. Refer to Brake Rotor Replacement in Disc Brake Systems.
7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Wheels, Tires and Alignment.
Tighten the wheel nuts to 140 Nm (100 ft. lbs.).

Notice: Refer to Fastener Notice in Service Precautions.