Power Accessory Switch Panel Replacement

REMOVAL PROCEDURE




1. Remove the trim panel (3).
2. Disconnect the passenger side temperature control switch harness (right side only).




3. Remove the two screws (2,4) and the six retainer clips (5) which retain the insert (7) to the trim panel.




4. Remove the insert panel (2) while guiding the wiring harness through the door panel.
5. Disengage the wiring harness from the retaining tab.




6. Disengage the tabs that retain the door lock/seat switch assembly (1) to the insert.
7. Remove the door lock/seat switch assembly (1) from the insert

INSTALLATION PROCEDURE




1. Install the door lock/seat switch assembly (1) into the insert.
2. Fasten the tabs in order to retain the door lock/seat switch assembly (1) to the insert.




3. Install the insert (2).




4. Install the two screws (2,4) and the six retainer clips (5) in order to retain the insert (7) to the trim panel.




5. Position the trim panel next to the door.
6. Connect the passenger temperature control switch harness (right side only).
7. Install the trim panel (3).