Daytime Running Lamp Resistor: Service and Repair

REMOVAL PROCEDURE
1. Remove the resistor bolt (2) from the left front fender.
2. Disconnect the connector (1).
3. Remove the daytime running lamp resistor (3).

INSTALLATION PROCEDURE
1. Connect the connector (1) to the daytime running lamp resistor (3).
2. Install the daytime running lamp resistor (3) to the front fender.

NOTE: Refer to Fastener Notice in Cautions and Notices.

3. Install the resistor bolt (2) to the front fender.

Tighten
Tighten the bolt to 7 N.m (62 lb in).