(With UW6) RPO

REMOVAL PROCEDURE
1. Open the rear compartment lid.
2. Disconnect the electrical connector.
3. Remove the speaker fasteners (3).
4. Turn the speaker slightly to disengage from the rear shelf tabs (1).
Remove the speaker (2).

INSTALLATION PROCEDURE
1. Partially install the speaker (2).
2. Turn slightly in order to engage the speaker into the rear shelf tabs (1).

NOTE: Refer to Fastener Notice in Cautions and Notices.

3. Install the speaker fasteners (3).

Tighten
Tighten the fasteners to 1.9 N.m (17 lb in).

4. Connect the electrical connections.
5. Close the rear compartment lid.