(With U97) RPO

REMOVAL PROCEDURE
1. Remove the rear door trim panel.
2. Remove the map pocket.
3. Remove the speaker fasteners.
4. Partially remove the speaker (1).
5. Disconnect the electrical connector.
6. Remove the speaker (1).

INSTALLATION PROCEDURE
1. Connect the electrical connector.
2. Install the speaker (1).

NOTE: Refer to Fastener Notice in Cautions and Notices.

3. Install the speaker fasteners.

Tighten
Tighten the fasteners to 1.9 N.m (17 lb in).

4. Install the map pocket..
5. Install the rear door trim panel.