A/T Mount Replacement (Right Mount)

REMOVAL PROCEDURE





1. Raise the vehicle. Support the vehicle. Refer to General Vehicle Lifting and Jacking in Service Precautions.
2. Remove the exhaust system. Refer to Exhaust System.
3. Remove the manifold-to-crossover pipe.
4. Remove the steering rack retaining bolts.
5. As necessary, position the steering rack away from the mount.
6. Support the transmission with the transmission jack.
7. Remove the through bolt and the nut.
8. Remove the mount-to-frame nuts and bolts.
9. Remove the mount from the frame.
10. Remove the mount-to-transmission bolts.
11. Remove the mount from the transmission.

INSTALLATION PROCEDURE





1. Install the mount to the transmission.
^ Tighten the bolts to the transmission to 110 Nm (81 ft. lbs.).

NOTICE: Refer to Fastener Notice in Service Precautions.

2. Install the mount to the frame.
^ Tighten the mount-to-frame nuts and bolts to 73 Nm (54 ft. lbs.).

3. Install the mount through bolt and nut.
^ Tighten the through bolt to 102 Nm (75 ft. lbs.).

4. Remove the transmission jack.
5. Install the steering rack.
6. Install the manifold crossover pipe.
7. Install the exhaust system. Refer to Exhaust System.
8. Lower the vehicle.