Upper Cover, Lower Cover - Floor Shift

Part 1 Of 2:

Part 2 Of 2:

REMOVE OR DISCONNECT
1. Disable the SIR system; refer to DISABLING THE SIR SYSTEM.
2. Tilt column to "CENTER" position.
3. Three tapping screws (26) from upper cover (17).
4. Upper cover (17).
5. Pan head screw (28).
6. Tilt lever knob (27).
7. Close out knob (18).
^ Pry locking tabs from bearing & housing assembly (11) and remove.
8. Three tapping screws (26) from lower cover (33).
9. Lower cover (33).
10. Wiring protector (14).

INSTALL OR CONNECT

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems. Failure to do so may result in component damage or malfunction of steering column.

1. Wiring protector (14).
2. Lower cover (33).
3. Three tapping screws (26) to lower cover (33).

Tighten
Tighten screws (26) to 2.5 Nm (22 lb in).

4. Close out knob (18).
^ Align locking tabs with slots in bearing & housing assembly (11) and install.
5. Pivot & pulse lever seal and multi-function lever seal into position.
6. Tilt lever knob (27).
7. Pan head screw (28).

Tighten
Tighten screws (28) to 3.5 Nm (31 lb in).

8. Upper cover (17).
9. Three tapping screws (26) to upper cover (17).

Tighten
Tighten screws (26) to 2.5 Nm (22 lb in).

10. If all service operations are completed, enable the SIR system; refer to ENABLING THE SIR SYSTEM.