Turn Signal & Multifunction Switch - Floor Shift

Part 1 Of 2:

Part 2 Of 2:

REMOVE OR DISCONNECT
1. Negative (-) battery cable.
2. Do steps 1 through 4 under REMOVE OR DISCONNECT in UPPER COVER LOWER COVER.





3. Two wire straps (31) from steering column wire harness.
4. Steering column bulkhead connector from vehicle wire harness.
5. Turn signal & multifunction switch (32) wire harness from wire harness strap (57).





6. Pivot & pulse switch assembly (16) connector from turn signal multifunction switch (32) wire harness connector.
7. Grey and black connectors of multifunction switch (32) from column bulkhead connector.
8. Pass key wire harness from grey turn signal switch connector.
A. 17-way secondary lock from connector.
B. Two pass key terminals from cavities 16 and 17.
9. Two tapping screws (26).
10. Multifunction switch assembly (32) from column.

INSTALL OR CONNECT

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems. Failure to do so may result in component damage or malfunction of steering column.

1. Turn signal & multifunction switch assembly (32) to column.
^ With small blade screwdriver compress electrical contact and move multifunction switch (32) into position.
^ Electrical contact must rest on cancelling cam assembly (7).

2. Two tapping screws (26).

Tighten
Tighten screws (26) to 2.5 Nm (22 lb in).

3. Pass key wire harness to grey turn signal switch connector.
A. Two pass key terminals to cavities 16 and 17 of connector. (cavities optional)
B. 17-way secondary lock to connector.
4. Grey and black connectors of multifunction switch (32) to column bulkhead connector.
5. Pivot & pulse switch (16) connector to turn signal & multifunction switch (32) wire harness connector.
6. Wire harness to wire harness strap (57).
7. Steering column bulkhead connector to vehicle wire harness.
8. Two wire straps (31) to steering column wire harness.
9. Pass key wire to securing position on multifunction switch (32).
10. Do steps 8 through 10 under INSTALL OR CONNECT in UPPER COVER LOWER COVER.
11. Negative (-) battery cable.