Interlock Solenoid Assembly - Column Shift

Part 1 Of 2:

Part 2 Of 2:

REMOVE OR DISCONNECT
1. Do all steps under REMOVE OR DISCONNECT in UPPER COVER LOWER COVER.





2. Two tapping screws (30) from bottom of bearing & housing assembly (11).
3. Interlock solenoid assembly (29) from column.
4. Electrical connector from turn signal & multifunction switch assembly (32) wire harness.

INSTALL OR CONNECT

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems. Failure to do so may result in component damage or malfunction of steering column.

1. Interlock solenoid assembly (29) to column.
2. Two tapping screws (30) to bearing & housing assembly (11).

Tighten
Tighten screws (30) to 2 Nm (18 lb in).

3. Electrical connector to turn signal & multifunction switch assembly (32) wire harness.
^ Wire strap (31).
4. Do all steps under INSTALL OR CONNECT in UPPER COVER LOWER COVER.