Ignition & Key Alarm Switch

Part 1 Of 2:

Part 2 Of 2:

REMOVE OR DISCONNECT
1. Do all steps under REMOVE OR DISCONNECT in UPPER COVER LOWER COVER.
2. Two wire straps (31) from steering column wire harness.
3. Steering column bulkhead connector from vehicle wire harness.





4. Ignition & key alarm switch assembly (22) wire harness from wire harness strap (57).
5. Grey and black connectors of turn signal & multifunction switch (32) from column bulkhead connector.
6. Two tapping screws (23).
7. Ignition switch assembly (22).

INSTALL OR CONNECT

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems. Failure to do so may result in component damage or malfunction of steering column.

1. Ignition & key alarm switch assembly (22).
2. Two tapping screws (23).

Tighten
Tighten screws (23) to 1.5 Nm (13 lb in).

3. Grays and black connectors of turn signal & multifunction switch (32) to column bulkhead connector.
4. Wire harness to wire harness strap (57).
5. Steering column bulkhead connector to vehicle wire harness.
6. Two wire straps (31) to steering column wire harness.
7. Do all steps under INSTALL OR CONNECT in UPPER COVER LOWER COVER.