Installation Procedure

1. Install the outside belt assembly.

NOTICE: Refer to Fastener Notice in Service Precautions.

2. Install the lower anchor bolt.
Tighten
Tighten the lower anchor bolt to 30 N.m (22 lb. ft).
3. Install the upper retractor anchor bolt.
Tighten
Tighten the lower anchor bolt to 30 N.m (22 lb. ft).
4. Install the rear seat-to-rear window trim panel. Refer to Body Rear End in Body and Accessories.
5. Install the quarter trim panel. Refer to Body Rear End in Body and Accessories.
6. Install the seatback. Refer to Seats in Body and Accessories.

Description:

7. Install the center lap belt assembly.
8. Install the anchor bolts.
Tighten
Tighten the anchor bolts to 30 N.m (22 lb. ft).
9. Install the seat cushion. Refer to Seats in Body and Accessories.