Installation Procedure

Description:

1. Install the dual retractor and lower anchor bolt.

NOTICE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the anchor bolt to 41 N.m (30 lb. ft).

Description:

2. Install the intermediate guide and screw.

Tighten
Tighten the screw to 2 N.m (17 lb. in).

Description:

3. Install the guide loop and the anchor bolt.

Tighten
Tighten the anchor bolt to 41 N.m (30 lb. ft).

Description:

4. Install the lower center trim.

Description:

5. Install the upper center pillar trim.