Accelerator Controls (Bracket) Replacement

REMOVAL PROCEDURE

Description:

1. Remove the cruise control cable (2) from the accelerator controls cable bracket (1).

2. Remove the accelerator cable (3) from the accelerator controls cable bracket (1).

Description:

3. Remove the -fuel feed and return pipes from the accelerator controls cable bracket (1) retainer.






4. Remove the transaxle vent hose (2) clip from the accelerator controls cable bracket (1).

Description:

5. Remove the transaxle shift cable clip from the accelerator controls cable bracket.

Description:

6. Remove the bolts from the accelerator controls cable bracket.


INSTALLATION PROCEDURE

1. Install the accelerator controls cable bracket.

Tighten the bolts to 12 N.m (106 lb. in).

2. Install the transaxle shift cable clip to the accelerator controls cable bracket.

3. Install the transaxle vent hose (2) clip to the accelerator controls cable bracket (1).

4. Install the fuel feed and return pipes to the accelerator controls cable bracket (1) retainer.

5. Install the accelerator cable (3) to the accelerator controls cable bracket (1).

6. Install the cruise control cable (2) to the accelerator controls cable bracket (1).

IMPORTANT: Make sure that cables are not rubbing or binding in any manner. The throttle should operate freely without bind between full closed and wide open throttle.