Flash-to-Pass

Battery positive voltage (B+) is applied through the engine compartment junction block FOG LAMP Fuse via CKT 42 (RED) at all times to the headlamp dimmer switch. When the multi-function lever (turn signal) is pulled towards the driver, battery positive voltage (B+) is applied through the headlamp dimmer switch to the LH and RH high beam headlamps via CKT 11 (LT GRN). If the headlamps are off, pulling the lever will turn the high beam headlamps on for as long as you hold the lever. Releasing the lever will turn the headlamps off. If the low beam headlamps are on when the lever is pulled, the low beams will shift to high beams and remain there until the lever is pulled again. If the high beam headlamps are on when the lever is pulled, the high beams will shift to low beams and remain there until the lever is pulled again.