Remove

Installing-Removing Pulley Rotor & Bearing Assembly Retaining Ring:

Installing Pulley Rotor/Bearing Puller Guide:

Removing Pulley Rotor And Bearing Assembly:

Pulley Rotor Bearing Removal:

Remove or Disconnect

1. Remove the clutch plate and hub assembly as described previously.
2. Remove rotor and bearing assembly retaining ring, using snap ring pliers J 6083.
3. Install pulley rotor and hearing pulley guide J 33023-A to the front head and install J 41552 pulley rotor and bearing pulley down into the inner circle of slots in the rotor. Turn the J 41552 pulley clockwise in the slots in the rotor.
4. Hold the J 41552 pulley in place and tighten the pulley screw against the pulley guide to remove the pulley rotor and hearing assembly.
5. To prevent damage to the pulley rotor during bearing removal the rotor hub must be properly supported.
Remove the forcing screw from J 41552 pulley and, with the pulley tangs still engaged in the rotor slots, invert the assembly onto a solid flat surface or blocks as shown in image.
6. Drive the hearing out of the rotor hub with rotor hearing remover J 9398-A and J 29886 universal handle.

NOTICE: It is not necessary to remove the staking in front of the bearing to remove the hearing, however, it will be necessary to file away the old stake metal for proper clearance for the new hearing to he installed into the rotor here or the hearing may be damaged.