Troubleshooting Hints - Lumbar Seats

PERFORM BEFORE BEGINNING SYSTEM DIAGNOSIS
1. Check the RH rear junction block PWR ST circuit breaker for continuity. If open, check for a short to ground in CKT 1340 (ORN).
2. For Oldsmobile, check the RH rear junction block I/P 1 Fuse by visual inspection. If open, check for a short to ground in CKT 40 (ORN).
3. If the seat motor internal circuit breaker trips, it will not reset until voltage is removed from the motor.
4. Make sure G201 and G202 is clean and tight.
5. Before component replacement, check for poor connections at related component and in-line harness connector cavity connections.
6. Check for broken (or partially broken) wire inside of the insulation which could cause a system malfunction but prove good in a continuity/voltage check with a system disconnected. These circuits may be intermittent or resistive when loaded, and if possible, should be checked by monitoring for a voltage drop with the system operational (under load).
7. Check for proper installation of aftermarket electronic equipment which may affect the integrity of other systems.