Radio Replacement
Radio Assembly:
REMOVE OR DISCONNECT
1. Center trim plate assembly by pulling inboard to disengage tabs (4) from retainers.
2. Screws (2).
3. Radio from IP assembly.
4. Electrical connectors and antenna lead from radio.
INSTALL OR CONNECT
1. Electrical connectors and antenna to back side of radio.
2. Slide radio in opening and insert pin (7) into guide (8).
3. Screws (2).
4. Center trim plate by aligning tabs (4) and locating pins (3) to retaining slots in IP assembly, applying pressure until tabs are fully seated.