Window Regulator Motor - Front

Oldsmobile
CAUTION: If door module assembly is removed from vehicle, relieve tension on actuator spring using tool J 38864 or equivalent. Failure to relieve tension on actuator spring could cause the cross arm assembly to suddenly spring closed when removing power window actuator, resulting in personal injury.

Actuator - Power Window (Motor)
Remove or Disconnect
1. Ensure window is 1 inch below full up position.






2. Door trim panel.
3. Negative battery cable.
4. Two trim panel retaining screws.
5. Slide pull handle lower inboard to disengage from switch plate.
6. Switch plate.'
7. Door lock switch plate.
8. Using J 38778, release trim panel retainers and trim panel.
9. Speaker(s).






10. Water deflector by peeling deflector off door inner panel.






11. Nuts
12 Actuator.

Install or Connect
1. Actuator.
2. Nuts
3. Water deflector to door inner panel, making sure to slick out wrinkles.
4. Slick bottom frrst, then the sides, then top, so there are no wrinkles.
5. Speakers(s).
6. Door trim panel.
7. Trim panel and retainers.
8. Armrest switch plate.
9. Pull handle lower to switch plate.
10. Two trim panel retaining screws and courtesy lamp.
11. Door lock switch plate.
12. Negative battery cable.