Troubleshooting Hints

PERFORM BEFORE BEGINNING SYSTEM DIAGNOSIS
1. Check Rear Fuse Block PWR DR LK Fuse by operating the power door locks. If open, check ORN (CKT 1540) for a short to ground.
2. Check seat belt for binding that could prevent it from retracting.
3. Make sure ground G201 is clean and tight.
4. Check for a broken (or partially broken) wire inside of the insulation which could cause system failure but prove GOOD in a continuity/voltage check. (Refer to General Troubleshooting Procedures.)
5. Check for proper installation of aftermarket electronic equipment which may effect the integrity of other systems. (Refer to General Troubleshooting Procedures.) Diagnostic Aids