EGR Valve (Water Pump Crossover Pipe)

EGR Valve Water Pump Crossover Pipe:

Removal Procedure
1. Remove the water pump belt shield.
2. Remove the bolt from throttle body spacer.
3. Remove the fitting at the water pump crossover.
4. Remove the EGR Water Pump Crossover Pipe.

Installation Procedure
1. Install the fitting into water pump crossover. Tighten the fitting to 24 Nm (18 lb ft).
2. Install the bolt into the throttle body spacer. Tighten the bolt to 24 Nm (18 lb ft).
3. Install the water pump belt shield.