Cylinder Head Cover - Right

1. Disconnect battery ground cable.
2. Remove intake manifold sight shield. Refer to Engine Cover Replacement Service and Repair
3. Remove vacuum reservoir.
4. Remove cruise control servo and position aside.
5. Disconnect DIS ignition module wiring connectors, then remove DIS module attaching bolts.
6. Remove DIS ignition module and spark plug wires from valve cover.
7. Remove PCV valve and canister purge solenoid from valve cover.
8. Raise and support vehicle.
9. Disconnect the following electrical connectors:
a. Knock sensor.
b. Vehicle speed sensor.
c. Power steering pressure switch.
10. Lower vehicle, then remove wiring harness retainers from cover.
11. Remove valve cover attaching bolts, then the valve cover.
12. Reverse procedure to install.