Remote Function Actuator (RFA) Module

RFA module is located in rear luggage compartment underneath right side of package shelf.

Important: When the RFA module is being replaced, it is very important to follow installation procedure carefully. Failure to do so will cause inoperative or malfunctions in the RFA system.

Remove or Disconnect

1. Open rear luggage compartment.

2. Electrical connector from RFA module.

3. Slide RFA module from bracket.

Install or Connect

1. Slide RFA module onto bracket.

2. Electrical connector.

3. Program transmitters, refer to procedure in this Section.

4. Connect TECH 1.

5. Turn ignition to ON.

6. Select vehicle being programmed.

7. Select "Body".

8. Select "RFA".

9. Select "RFA Test".

10. Select "Set Options".

11. Select "Options 0".

Important:

^ Follow screen prompts and instructions.

^ Use the EXIT key to change from one function screen to another. Do Not use the YES or NO keys. If YES or NO is pressed, other features may become disabled.

12. Scroll through screens until desired function is displayed, select on each function that needs to be enabled for the particular vehicle being serviced.

^ Use RFA function chart in this Section and select the functions that are standard or optional for the particular vehicle being serviced. Failure to program the RFA module properly will cause the system to malfunction causing misdiagnosis and customer concerns.

^ When selecting tunctions on a new RFA module on a vehicle that has Theft Deterrent (UA6), you must go into Option 3 on TECH 1. will appear as your only selection, select , then EXIT the system. If this function is not reset, the 30 second Theft lamp illumination will be reduced to 2 seconds. Misdiagnosis of the Theft Deterrent system may occur if this function is not set properly.

13. Exit system.

14. Disconnect TECH 1.