Rear Door: Service and Repair

TRIM PANEL - REAR DOOR

REMOVE OR DISCONNECT
1. Switch plate by pulling up on forward edge of plate.
2. Electrical connectors.
3. Bezel cup by removing finish plug and one screw.
4. Two screws from bottom edge of panel.
5. Trim panel by pulling up to disengage hooks on backside of trim panel.
6. Electrical connectors.

INSTALL OR CONNECT
1. Electrical connectors.
2. Trim panel by engaging hooks on backside of trim panel into door inner panel.
3. Two screws in bottom edge of panel.
4. Bezel cup and one screw.
5. Electrical connectors to switch plate.
6. Switch plate.