Troubleshooting Hints - Power Windows

PERFORM BEFORE BEGINNING SYSTEM DIAGNOSIS
1. Always check terminal contact before replacing any component.
2. If all power windows are inoperative, check PWR WDO/ SUNRF circuit breaker in rear fuse block. Reset circuit breaker if tripped. If circuit breaker trips again when ignition switch is set to RUN position, check for short to ground in CKT 141.
3. If windows move slowly, check that:
^ Windows are free of mechanical binding; pivot joints are greased.
^ Battery is fully charged.
^ Ground G202 is clean and tight.
4. If a motor's internal circuit breaker trips, it does not reset until voltage is removed from motor.
5. If power windows do not operate for approximately 10 minutes (or until a door is opened) after ignition switch is turned to OFF position, refer to Accessory Delay Module for diagnosis.

Accessory Delay Module