I/P Cluster - Removal/Installation Revised

File In Section: 8 - Chassis/Body Electrical

Bulletin No.: 43-83-23

Date: January, 1995

Subject:
Section 8C - Revised Removal and Installation Procedure for I/P Cluster

Model:
1995 Oldsmobile Aurora

Please replace the I/P cluster removal and installation procedure in Section 8C with the following:

REMOVE OR DISCONNECT

1. Disable Supplemental Inflatable Restraint (SIR). Refer to procedure in Section 8C.

2. Knee bolster. Refer to procedure in Section 8C.

3. Upper steering column bracket nuts (2). Refer to Section 3F, Lower Steering Column.

4. Trunk/fuel door release trim plate and interior lamp trim plate by pulling rearward. Disconnect electrical connectors as necessary.

5. Center A/C outlet trim panel.

6. I/P cluster trim panel, pull down and rearward to clear upper I/P trim pad.

7. Screws (5) from I/P cluster.

8. Unplug two (2) electrical connectors on back of I/P cluster.

9. I/P cluster from I/P assembly.

INSTALL OR CONNECT

1. I/P cluster to I/P assembly.

2. Two (2) electrical connectors to back of I/P cluster.

3. Screws (5) from I/P cluster to I/P assembly.

4. Steering column bracket nuts (2), refer to Section 3F.

5. Knee bolster, refer to procedure in Section 8C.

6. I/P cluster trim panel.

7. Center A/C outlet trim panel.

8. Trunk/fuel door release door trim plate and interior lamp trim plate. Connect electrical connectors as necessary.

9. Enable SIR, refer to procedure in Section 8C.