Test B: Connector C2 Pinout Test

B: Connector C2 Pinout Test:

^ Instrument cluster connector C2: Disconnected.
^ Make all voltage measurements with ignition switch in "RUN" unless otherwise indicated.
^ Make all resistance measurements to ground with ignition switch in "LOCK" unless otherwise indicated.
^ Measure to ground unless another terminal is given.
^ If any measurement is incorrect, check wiring for an open or short to ground; Check applicable in-line connectors (see schematic) for proper terminal contact.
^ If all checks and measurements are correct, check instrument cluster connector for proper terminal contact. If ok replace instrument cluster. Repeat system check.