Traction Control Switch - Falls Through Shifter Plate
File In Section: 8 - Chassis/Body ElectricalBulletin No.: 43-83-13
Date: September, 1994
Subject:
Traction Control Switch Falls through Shifter Trim Plate and into Center Console (Install Felt Tape)
Model:
1995 Oldsmobile Aurora
Condition
Some owners may comment on the traction control on/off switch falling through the shifter trim plate into the center console.
Cause
A variation in switch to trim plate tolerances may cause this condition.
Correction
1. Remove the shifter trim plate by following the procedure in Section 8C of the Service Manual.
2. Retrieve the traction control switch from the center console.
3. Install felt tape (available locally) on sides of traction control switch below retainer tabs as shown in the illustration.
4. Install traction control switch into shifter trim plate and verify proper installation.
5. Install shifter trim plate by following the procedures in Section 8C of the Service Manual.
Warranty Information
For vehicles repaired under warranty, use:
Labor Operation: N2584
Labor Time: Use published labor operation time.