DTC 95

DTC 95 Chart:

Ignition System Circuit:

CIRCUIT DESCRIPTION
The Powertrain Control Module (PCM) monitors engine speed and stores DTC 95 if an engine stall or near stall is detected.

DTC 95 WILL SET WHEN
- Engine speed is initially over 400 RPM, indicating run mode.
- Engine speed drops to 0 RPM.
- Ignition has not been turned "OFF."

ACTION TAKEN (PCM WILL DEFAULT TO)
When DTC 95 is set, the PCM stores a snapshot of the conditions present when the stall occurred. DTC 95 does not illuminate the Malfunction Indicator Lamp (MIL) (Service Engine Soon).

DTC 95 WILL CLEAR WHEN
The fault no longer exists.

DIAGNOSTIC AIDS
When DTC 95 sets the PCM will "Snapshot" data parameters that can be retrieved by using the Tech 1. Refer to PCM Snapshot Data in Scan-Tool Diagnosis. Scan Tool Testing and Procedures