Disassembly and Assembly

COOLING FAN

Disassembly and Assembly


DISASSEMBLY

1.Disconnect sub-harness from fan motor and cooling fan control module.
2.Remove cooling fan control module from fan shroud.

CAUTION:
Handle it carefully and avoid subjecting it to impact.
3.Remove fan mounting nuts, and then remove the fan.
4.Remove fan motor.
- Identify installation position of each valve. Arrange removed valves so that they cannot be mixed up.

ASSEMBLY

Note the following, and assemble in the reverse order of disassembly.
- If fan motor is reused, install in its original position.
- Install each fan in the following position.
Vehicle left Vehicle right


Models with heat pump
9 fans11 fans systems
Models without heat
6 fans9 fans pump systems
- Apply thread locking adhesive (Three Bond Thread Lock Super 1303 or an equivalent) to the threads of the fan motor shaft, and tighten the fan mounting nuts.
- Secure the sub-harness tightly to the fan shroud to prevent it from interfering with the fan rotation area.