Removal And Installation

CVT OIL WARMER SYSTEM

WATER HOSE : Removal and Installation


WARNING:
Never remove the radiator cap when the engine is hot. Serious burns could occur from high pressure coolant escaping from the radiator.

CAUTION:
Perform this procedure when engine is cold.
NOTE:
When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spilling.

REMOVAL

1.Remove air duct (inlet). Component.
2.Remove hose clamps, and remove CVT water hose A.
3.Remove hose clamps, and remove CVT water hose B.
4.Remove hose clamps, and remove CVT water hose C.
5.Remove CVT water tube.

INSTALLATION

Installation is in the reverse order of removal.
When installing water hoses, install them according to the following:





- Insert CVT water hose according to dimension "A" described below.










- Set hose clamps (1) at the both ends of fluid cooler hose (2) with dimension (A) from the hose edge.
Dimension (A): 5 - 7 mm (0.20 - 0.28 in)
- Hose clamp should not interfere with the bulge.










- The illustrations indicate the view from the hose ends.





- When installing hose clamps the center line of each clamp tab should be positioned as shown.