Side Curtain Air Bag Module

SIDE CURTAIN AIR BAG MODULE

Removal and Installation


REMOVAL


WARNING:
- When servicing the SRS, do not work from directly in front of air bag module.
- Always place the curtain air bag module with deployment side facing upward.
- Do not reuse center pillar upper garnish if removed.

CAUTION:
- Before servicing SRS, turn the ignition switch OFF, disconnect both battery terminals and wait at least three minutes.
- Do not use old bolts after removal; replace with new bolts.
- Do not insert any foreign objects (screwdriver, etc.) into air bag module or harness connectors.
- Do not disassemble air bag module.
- Do not expose the side curtain air bag module to temperatures exceeding 90�C (194�F).





- Replace the side curtain air bag module if it has been dropped or sustained an impact.
- Do not allow oil, grease or water to come in contact with the side curtain air bag module.

- Do not attempt to repair or replace damaged direct-connect
SRS component connectors. If a direct-connect harness connector is damaged, the harness must be replaced.
1.Disconnect both the negative and positive battery terminals, then wait at least three minutes.
2.Remove the headlining. Removal And Installation.





3.Disconnect side curtain air bag module connector.
NOTE:
For removal/installation of the direct-connect SRS connectors, Supplemental Restraint System (SRS).
4.Remove the bolts in order starting at the rear, then remove the side curtain air bag module.

INSTALLATION

Installation is in the reverse order of removal.
NOTE:
- For removal/installation of the direct-connect SRS connectors, Supplemental Restraint System (SRS).
- After replacement of side curtain air bag module, perform self-diagnosis to check that no malfunction is detected. SRS Operation Check.