Removal and Installation

EVAPORATIVE EMISSION SYSTEM

Removal and Installation


EVAP CANISTER

Removal
1.Remove EVAP canister cover.
2.Disconnect the EVAP control pressure sensor connector.
3.Disconnect EVAP canister purge hose, and drain the hose.
4.Remove the EVAP canister retaining bolt.
5.Disconnect fuel tank EVAP breather hose.
6.Disconnect EVAP canister vent control valve connector.
7.Disconnect the EVAP canister vent control valve hose.
8.Remove the EVAP canister.
9.Remove the EVAP vent control valve and O-ring, if necessary.
Installation
Installation is in the reverse order of removal.

CAUTION:
Do not reuse O-rings.

EVAP CANISTER CONTROL PRESSURE SENSOR

Removal
1.Remove EVAP canister cover.
2.Disconnect the EVAP control system pressure sensor connector.
3.Remove the EVAP control system pressure sensor and O-ring.
Installation
Installation is in the reverse order of removal.

CAUTION:
Do not reuse O-rings.

EVAP CANISTER VENT CONTROL VALVE






1.Remove EVAP canister cover.
2.Disconnect EVAP canister vent control valve connector.
3.Disconnect the EVAP canister purge hose, and drain the hose.
4.Turn EVAP canister vent control valve counterclockwise to unlock.
5.Remove the EVAP canister vent control valve.
Installation
Installation is in the reverse order of removal.

CAUTION:
Do not reuse O-rings.