Spoiler: Service and Repair

REAR AIR SPOILER

Removal and Installation


Exploded View












Removal

1.Remove back door finisher upper.
2.Disconnect high mounted stop lamp connector.
3.Remove the nuts and carefully lift the rear air spoiler from the back door.

CAUTION:
Use care not to damage painted surfaces during removal, or releasing of adhesive backed foam tapes if equipped.
4.Release the high mounted stop lamp harness grommet from back door, then remove rear air spoiler.

Installation

Installation is in the reverse order of removal.
NOTE:
- Before installing rear air spoiler, clean the surface where it will be mounted with isopropyl alcohol or equivalent to degrease the surface.
- Before installing, be sure there are no gaps or waves in the foam tape (if equipped) where the surfaces meet.
- During installation, be sure grommet of high mounted stop lamp harness is fully seated into back door opening prior to final rear air spoiler placement.