Rear Coil Spring

COIL SPRING

Removal and Installation


REMOVAL

1.Set jack under rear suspension beam.





2.Remove both shock absorber lower bolts (A).
3.Gradually lower the jack, and then remove coil spring, bound bumper and rear spring rubber seat.

INSPECTION AFTER REMOVAL

Check coil spring and spring rubber seat for deformation, cracks, and damage, and replace it if a malfunction is detected.

INSTALLATION

Installation is in the reverse order of removal. For tightening specifications, Rear Suspension Assembly .
- When installing rear spring rubber seat, be sure that the flat areas (A) are aligned.










- When installing rear spring, be sure that the gap (A) is less than
5mm (0.20 in).