Can not Be Changed To Manual Mode

TROUBLE DIAGNOSIS FOR SYMPTOMS

Cannot Be Changed to Manual Mode


SYMPTOM:

Does not change to manual mode when manual shift gate is used.

DIAGNOSTIC PROCEDURE


1. CHECK SELF-DIAGNOSTIC RESULTS

Perform self-diagnosis check. CVT Trouble Diagnosis .
Is any malfunction detected by self-diagnosis?
YES- Check the malfunctioning system. CVT Trouble Diagnosis .
NO- GO TO 2.

2. CHECK MANUAL MODE SWITCH

Check the manual mode switch circuit. Refer to {LINK_TO_MANY:0000000007402460}{LINK_TO_MANY:0000000007402461}{LINK_TO_MANY:0000000007402462}{LINK_TO_MANY:0000000007402463}{LINK_TO_MANY:0000000007402464} .
OK or NG
OK- GO TO 3.
NG- Repair or replace damaged parts.

3. SYMPTOM CHECK

Check again. CVT Trouble Diagnosis .
OK or NG
OK-INSPECTION END
NG- GO TO 4.

4. CHECK TCM

1.Check TCM input/output signals. CVT Trouble Diagnosis .
2.If NG, re-check TCM pin terminals for damage or loose connection with harness connector.
OK or NG
OK-INSPECTION END
NG- Repair or replace damaged parts.