Removal And Installation

EARTH BRUSH

Removal and Installation


REMOVAL

1.Remove front under cover. Refer to "FRONT UNDER COVER : Exploded View" Floor Side Fairing.





2.Disconnect breather hose (1) from brush cover (2), then remove the brush cover bolts (A) and remove brush cover.





3.Remove O-ring (1). Remove brush fixing bolts (A), then remove earth brush.

CAUTION:
- Carefully remove earth brush, because the spring in the earth brush pushes out the brush.
- Never touch brush area.

INSTALLATION

Note the following, and install in the reverse order of removal.

CAUTION:





- Degrease shaft surface (brush contact surface) (A), and verify that there is no dust or other substance on it, then install the earth brush.


- Degrease brush surface, and verify that there is no dust or other substance on it, then install the earth brush.
- Never reuse O-ring.
- Never apply oil to O-ring. Verify that there is no oil on it, then install O-ring.
- Never touch brush area.
- When assembling earth brush, do not touch brush area (A), press earth brush (2) onto shaft (1) and fasten with brush fixing bolt.






CAUTION:





Never touch brush area (A).
When Replacing With New Part
NOTE:
A new earth brush includes a stopper for preventing brush pop-out. Install with stopper attached.





When installing a new earth brush, pull out stopper (1) after installation, allowing brush to contact shaft.

CAUTION:
Before installation, degrease the stopper surface (shaft side)
and check that the surface is free of foreign matter.