Removal and Installation

COOLING FAN

Removal and Installation


REMOVAL

1.Remove radiator core support upper. Refer to "RADIATOR CORE SUPPORT UPPER : Removal and Installation" Radiator Core Support Upper.
2.Remove water hose bracket from front side of traction motor inverter. Refer to "Exploded View" Exploded View.
3.Remove radiator cooling fan assembly with the following procedure.
a.Disconnect the harness between cooling fan and vehicle body at cooling fan control module.
b.While pressing left and right pawls (1) of the radiator, raise the radiator cooling fan assembly in upward direction (), and separate fitting of the radiator and the radiator cooling fan assembly.





c.Pull out and remove the cooling fan shroud with the left side of cooling fan shroud (1) facing upward.






CAUTION:
Be careful not to damage radiator core.

INSTALLATION

Note the following, and install in the reverse order of removal.
- When the radiator cooling fan assembly is installed, insert the fitting area securely as shown by the arrow () in the figure.