Rear Door Limiter: Service and Repair

REAR DOOR

DOOR CHECK LINK : Removal and Installation


REMOVAL

1.Fully close the rear door window.
2.Remove rear door finisher. Refer to "Removal and Installation" Removal And Installation.
3.Remove mounting bolts of rear door speaker, and then remove rear door speaker.
4.Disconnect harness connector of rear door speaker.
5.Remove mounting bolt of the check link on the vehicle.
6.Remove mounting bolts of the check link on door panel.





7.Take door check link (1) out from the hole of door panel (2).

INSTALLATION

Note the following items, and install in the reverse order of removal.

CAUTION:
- Check rear door open/close operation after installation.





- Check door check link rotating part for poor lubrication. If necessary, apply grease.