Removal And Installation

FRONT DOOR GLASS

Removal and Installation


REMOVAL

1.Fully open front door glass.
2.Remove front door finisher. Removal And Installation.
3.Remove pull handle bracket.
4.Disconnect front door speaker harness connector and remove front door sealing screen.
NOTE:
Cut the butyl-tape so that some parts of the butyl-tape do not remain on the sealing screen, if the sealing screen is reused.
5.Operate the power window main switch or regulator handle to raise or lower the door window until the glass mounting bolts can be seen.
6.Remove the glass mounting bolts.
7.Remove lower sash (rear).
1.Remove front door glass from front door regulator and place it on the bottom of front door panel.

CAUTION:
Wrap the tip of front door glass bottom side with a cloth to protect it from damage.
2.Remove front door glass run.
3.Remove lower sash (rear) mounting bolts and remove lower sash (rear).

CAUTION:
Avoid contact between lower sash (rear) and front door glass when removing.





8.Hold securely the front door glass and pull it out of the sash to remove the door glass as shown in the figure.
9.Remove lower sash (front).
1.Remove lower sash (front) mounting bolt.
2.Reach the bottom part of lower sash (front) and then pull it toward rear of vehicle.
3.Hold the upper part of lower sash (front) and then pull it up to remove.

INSTALLATION

Install in the reverse order of removal.