AWD Mode Indicator Lamp (AWD-V)

AWD MODE INDICATOR LAMP (AWD-V)

Component Function Check


1. AWD MODE INDICATOR LAMP OPERATION CHECK

1.Turn the ignition switch ON.
2.Set AWD mode switch to "AWD-V".
3.Check that AWD mode indicator lamp (AWD-V) turns on.
Is the inspection result normal?
YES- INSPECTION END
NO- Proceed to .


Diagnosis Procedure


1. CHECK AWD WARNING LAMP

1.Start the engine and drive at 30 km/h (19 MPH) or more for approximately 1 minute.
2.Stop the vehicle.
Does AWD warning lamp turn ON?
YES- Proceed to AWD Warning Lamp.
NO- GO TO 2.

2. CHECK AWD MODE SWITCH

Perform the trouble diagnosis for AWD mode switch. P1813.
Is the inspection result normal?
YES- GO TO 3.
NO- Repair or replace the error-detected parts.

3. CHECK AWD MODE INDICATOR LAMP SIGNAL

With CONSULT
1.Start the engine.

CAUTION:
Never drive the vehicle.
2.Change AWD mode switch to "AWD-V" from "2WD".
3.Check "INDICATOR" in "DATA MONITOR" for "ALL MODE AWD/4WD".
Does the item on "DATA MONITOR" indicate "AWD-V"?
YES- GO TO 4.
NO- Replace AWD control module. Removal And Installation.

4. CHECK COMBINATION METER POWER SUPPLY CIRCUIT

Perform the trouble diagnosis for combination meter power supply circuit. Power Supply And Ground Circuit.
Is the inspection result normal?
YES- INSPECTION END
NO- Repair or replace the error-detected parts.