Removal And Installation

AWD CONTROL MODULE

Removal and Installation


REMOVAL

1.Turn the ignition switch OFF.
2.Remove front seat (left side). Removal and Installation.
3.Remove dash side finisher (left side). Dash Side Finisher.
4.Remove front and rear kicking plate inner. Kicking Plate Inner.
5.Remove rear seat cushion. Seat Cushion.
6.Remove outer anchor of front seat belt (passenger side). Front Seat Belt.
7.Remove harness clip.
8.Turn floor carpet. Removal And Installation.
9.Disconnect AWD control module harness connector.
10.Remove AWD control module mounting nuts.
11.Remove AWD control module.

INSTALLATION

Note the following, and install in the reverse order of removal.
- When installing AWD control module, install it following procedure.





1.Align the securing holes (A) of bracket as shown in the figure and temporarily tighten mounting bolts.

White arrow indicates : Vehicle front

2.When replace AWD control module, hold AWD control module and remove protector paper on the adhesion area of bracket to bond to the front floor (LH).
3.Tighten mounting bolts to the specified torque.
- When replacing AWD control module, perform writing unit parameter. Work Procedure.