Removal And Installation

POSITION SWITCH

Removal and Installation


REMOVAL

1.Remove battery. Removal And Installation.
2.Disconnect position switch connector.
3.Remove position switch from transaxle case.

INSTALLATION

1.Apply recommended sealant to threads of position switch.
-Use Genuine Silicone RTV or an equivalent. Recommended Chemical Products And Sealants.

CAUTION:
Remove old sealant and oil adhering to threads.
2.Install position switch to transaxle case.
3.Tighten position switch to the specified torque. Exploded View.
4.For the next step and after, install in the reverse order of removal.