Removal And Installation

AIR CLEANER AND AIR DUCT

Removal and Installation


REMOVAL

NOTE:
Mass air flow sensor is removable under the car-mounted condition.
1.Remove engine cover. Exploded View.
2.Remove air duct inlet (upper).
3.Remove the air cleaner filter from the air cleaner case.
4.Disconnect mass air flow sensor harness connector, and remove harness clamp from air cleaner body.
5.Remove air cleaner body assembly.
6.Remove the air duct (suction side).
- Add matching marks if necessary for easier installation.
7.Remove air cleaner cover assembly.
8.Remove mass air flow sensor from air cleaner cover, if necessary.

CAUTION:
Handle the mass air flow sensor with following cares.
- Never shock the mass air flow sensor.
- Never disassemble the mass air flow sensor.
- Never touch the sensor of the mass air flow sensor.
9.Remove air duct inlet (lower) with the following procedure.
a.Remove fender protector (LH). Exploded View.
b.Remove air duct inlet (lower).

INSTALLATION

Note the following, and install in the reverse order of removal.
- Align marks. Attach each joint. Screw clamps firmly.
- Fixing clips shall be fixed after inserting air cleaner body assembly protrusion to air cleaner case botch hole.
- Make sure whether air cleaner body has been firmly installed by shaking it.