Shift Position Indicator Circuit

SHIFT POSITION INDICATOR CIRCUIT

Description

- TCM sends position indicator signals to combination meter by CAN communication line.
- Manual mode switch position is indicated on shift position indicator.


Component Function Check


1. CHECK SHIFT POSITION INDICATOR


CAUTION:
Always drive vehicle at a safe speed.
1.Start engine.
2.Check if correct selector lever position ("P", "N", "R" or "D") is displayed as selector lever is moved into each position.
3.Drive vehicle in the manual mode, and confirm that the actual gear position and the meter's indication of the position mutually coincide when the selector lever is shifted to the "UP (+ side)" or "DOWN (- side)" side (1st <==> 6th gear).
Is the inspection result normal?
YES- INSPECTION END
NO- Go to .


Diagnosis Procedure


1. CHECK INPUT SIGNALS

With CONSULT
1.Start engine.
2.Check if correct selector lever position ("P", "N", "R" or "D") is displayed as selector lever is moved into each position.
3.Select "RENGE" on "DATA MONITOR" and read out the value.
4.Drive vehicle in the manual mode, and confirm that the actual gear position and the meter's indication of the position mutually coincide when the selector lever is shifted to the "UP (+ side)" or "DOWN (- side)" side (1st <==> 6th gear).
Is the inspection result normal?
YES- INSPECTION END
NO - 1 -The actual gear position does not change, or shifting into the manual mode is not possible (no gear shifting in the manual mode possible). Or the shift position indicator is not indicated.
- Check manual mode switch. P0826.
- Check CVT main system (Fail-safe function actuated).
- Perform "SELF-DIAG RESULTS" mode for "TRANSMISSION". CONSULT Function.
NO - 2 -The actual gear position changes, but the shift position indicator is not indicated.
- Perform "SELF-DIAG RESULTS" mode for "TRANSMISSION". CONSULT Function.
NO - 3 -The actual gear position and the indication on the shift position indicator do not coincide.
- Perform "SELF-DIAG RESULTS" mode for "TRANSMISSION". CONSULT Function.
NO - 4 -Only a specific position or positions is/are not indicated on the shift position indicator.
- Check the combination meter. Work Flow.