Removal And Installation

ACCELERATOR CONTROL SYSTEM

Removal and Installation


REMOVAL

1.Remove instrument panel lower cover driver side.
2.Disconnect accelerator pedal position sensor harness connector.
3.Loosen mounting bolts, and remove accelerator pedal assembly.

CAUTION:
- Never disassemble accelerator pedal assembly. Never remove accelerator pedal position sensor from accelerator pedal assembly.
- Avoid impact from dropping etc. during handling.
- Be careful to keep accelerator pedal assembly away from water.

INSTALLATION

Note the following, and install in the reverse order of removal.
- Insert the locating pin while inserting the locating hook in to the break pedal bracket. Tighten mounting bolts to accelerator pedal assembly.

CAUTION:
Never squeeze the locating hook into the break pedal bracket when inserting the locating pin into the hole on the brake pedal bracket side.