Parking Light Bulb: Service and Repair

REAR COMBINATION LAMP

Replacement


CAUTION:
- Disconnect the battery negative terminal or the fuse.
- Never touch the glass of bulb directly by hand. Keep grease and other oily matters away from it.
- Never touch bulb by hand while it is lit or right after being turned off.
- Never leave bulb out of lamp reflector for a long time because dust, moisture smoke, etc. may affect the performance of lamp. When replacing bulb, be sure to replace it with new one.

REAR TURN SIGNAL/TAIL LAMP BULB

1.Remove rear combination lamp assembly. Removal And Installation.
2.Rotate rear turn signal/tail lamp bulb socket counterclockwise, and then remove rear turn signal/tail lamp bulb socket.
3.Remove rear turn signal/tail lamp bulb from rear turn signal/tail lamp bulb socket.

STOP LAMP BULB

1.Remove rear combination lamp assembly. Removal And Installation.
2.Rotate stop lamp bulb socket counterclockwise, and then remove stop lamp bulb socket.
3.Remove stop lamp bulb from stop lamp bulb socket.

BACK-UP LAMP BULB

1.Remove rear combination lamp assembly. Removal And Installation.
2.Rotate back-up lamp bulb socket counterclockwise, and then remove back-up lamp bulb socket.
3.Remove back-up lamp bulb from back-up lamp bulb socket.